Premio-computer Apollo/Shadowhawk Manuale Utente Pagina 98
- Pagina / 153
- Indice
- SEGNALIBRI
Valutato. / 5. Basato su recensioni clienti
Technical Reference
75
CAUTION
Do not place jumpers on this block in any configuration other than the one described in Table 48.
Other jumper configurations are not supported and could damage the board.
Table 48. Front Panel Audio Connector / Jumper Block
Jumper Setting Configuration
1
34
6
9
7
5
2
10
5 and 6
9 and 10
Audio line out signals are routed to the back panel audio line out
connector. The back panel audio line out connector is shown in Figure 10
on page 54.
1
34
6
9
7
5
2
10
No jumpers
installed
Audio line out and mic in signals are available for front panel audio
connectors. Table 41 on page 71 lists the names of the signals available
on this connector when no jumpers are installed.
✏
NOTE
When the jumpers are removed and this connector is used for front panel audio, the back panel
audio line out and mic in connectors are disabled.
2.9.2 BIOS Setup Configuration Jumper Block
The 3-pin jumper block determines the BIOS Setup program’s mode. Table 49 describes the
jumper settings for the three modes: normal, configure, and recovery. When the jumper is set to
configuration mode and the computer is powered-up, the BIOS compares the processor version and
the microcode version in the BIOS and reports if the two match.
Table 49. BIOS Setup Configuration Jumper Settings
Function/Mode Jumper Setting Configuration
Normal
1-2
1
3
The BIOS uses current configuration information and
passwords for booting.
Configure
2-3
1
3
After the POST runs, Setup runs automatically. The
maintenance menu is displayed.
Recovery
None
1
3
The BIOS attempts to recover the BIOS configuration. A
recovery diskette is required.
For information about Refer to
How to access the BIOS Setup program Section 4.1, page 97
The maintenance menu of the BIOS Setup program Section 4.2, page 98
BIOS recovery Section 3.7, page 93
- Apollo/Shadowhawk 1
- System Manual 3
- Copyright 4
- Disclaimers 4
- Getting Started 7
- Setting Up 8
- Switches and Indicators 9
- 4 Premio System Manual 10
- Upgrading 11
- Opening the System Unit 12
- Installing an Expansion Card 13
- Installing a Hard Drive 14
- Getting Help 15
- Keyboard Does Not Work 16
- Mouse Does Not Work 16
- System Unit Problems 17
- Hard Drive Problems 17
- Technical Support 18
- Premio on the Internet 18
- Appendix 19
- Service Under Warranty 20
- FCC Standards 21
- 16 Premio System Manual 22
- Appendix 17 23
- Desktop Board 24
- D845HV/D845WN 24
- Revision History 25
- Intended Audience 26
- What This Document Contains 26
- Typographical Conventions 26
- Other Common Notation 27
- Contents 28
- 2 Technical Reference 29
- 3 Overview of BIOS Features 29
- 4 BIOS Setup Program 30
- Product Description 34
- Feature Summary 35
- Table 2. Feature Summary 35
- Manufacturing Options 36
- Board Layouts 37
- Block Diagram 39
- 1.3 Online Support 40
- 1.4 Operating System Support 40
- Table 4. Specifications 41
- IrDA Serial Physical 42
- Layer Specification 42
- Table 5. Supported Processors 44
- 1.7 System Memory 45
- 1.8 Intel 47
- 845 Chipset 47
- 1.8.1 AGP 48
- 1.8.2 USB 48
- IDE Support 50
- Serial Ports 52
- Infrared Support 53
- Parallel Port 53
- Diskette Drive Controller 54
- I/O Controller Option 54
- Audio Connectors 56
- Audio Subsystem Software 56
- 1.11.1 Intel 57
- LAN Subsystem Software 58
- Fan Monitoring 59
- 1.14 Power Management 60
- (Note 1) 62
- (Note 2) 62
- 1.14.1.3 Plug and Play 63
- Hardware Support 64
- 1.14.2.2 Fan Connectors 65
- Product Description 66
- 1.14.2.5 Resume on Ring 67
- 1.14.2.6 Wake from USB 67
- Technical Reference 70
- Table 13. I/O Map 71
- Table 13. I/O Map (continued) 72
- Table 14. DMA Channels 73
- Table 16. Interrupts 74
- Note: D845WN board only 75
- 2.8 Connectors 76
- Back Panel Connectors 77
- Table 19. USB Connectors 78
- Internal I/O Connectors 80
- Figure 11. Audio Connectors 81
- D845WN board 87
- Table 35. CNR Connector 88
- Table 36. PCI Bus Connectors 89
- Table 37. AGP Connector 90
- Table 39. PCI IDE Connectors 92
- External I/O Connectors 93
- (Optional) 94
- 2.9 Jumper Blocks 97
- D845HV Form Factor 99
- D845WN Form Factor 100
- I/O Shield 101
- Technical Reference 102
- Power Consumption 103
- Table 50. Power Usage 103
- Add-in Board Considerations 103
- Power Supply Considerations 105
- 2.12 Thermal Considerations 106
- 2.13 Reliability 108
- 2.14 Environmental 108
- Safety Regulations 109
- Table 55. Safety Regulations 109
- EMC Regulations 109
- Table 56. EMC Regulations 109
- Overview of BIOS Features 112
- PCI Autoconfiguration 113
- PCI IDE Support 113
- 3.5 Legacy USB Support 114
- 3.6 BIOS Updates 115
- Language Support 116
- Custom Splash Screen 116
- CD-ROM and Network Boot 117
- Intel Rapid BIOS Boot 118
- 3.10 BIOS Security Features 119
- BIOS Setup Program 120
- Maintenance 121
- Extended Configuration 121
- Table 60. Maintenance Menu 121
- Table 62. Main Menu 123
- 4.4 Advanced Menu 124
- PCI Configuration Submenu 125
- Boot Configuration Submenu 126
- IDE Configuration Submenu 129
- Video Configuration Submenu 134
- Maintenance Main Advanced 135
- Security 135
- Power Boot Exit 135
- Table 72. Security Menu 135
- Boot Exit 136
- Table 73. Power Menu 136
- ACPI Submenu 137
- 4.7 Boot Menu 138
- Hard Disk Drives Submenu 140
- Removable Devices Submenu 140
- ATAPI CD-ROM Drives Submenu 141
- Table 80. Exit Menu 142
- What This Chapter Contains 144
- Table 81. BIOS Error Messages 144
- 5.2 Port 80h POST Codes 146
- 5.4 Speaker (Optional) 151
- 5.5 BIOS Beep Codes 151
- Table 88. Beep Codes 152
© 2020, manymanuals.it. Tutti i diritti riservati | 0.051 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Commenti su questo manuale